Talk:Kolab2 Installation - Binary

From Kolab wiki

Need to run kolab_bootstrap after install but before rckolab?

A: it is hard to tell. If you talk about this piece of article:

Now remove the redundant rpms: 

kpm -e automake autoconf bison dbtool dcron file flex gmp make patch sed vim sharutils texinfo

Please check kolab still seems to work fine: 

rckolab all stop
rckolab all start

than I would say you don't need to run kolab_bootstrap at all as

that has been done during the installation process.

I didn't even get this far - there is no *still* seems to work. :o( Following these instructions I don't ever get to set up the server using kolab_bootstrap - specifying master/slave, domain name, etc. I guess I may have missed an instruction telling me to do so from obmtool.

I've built again successfuly using the instructions for build from source, which do mention this step. --128.240.229.65 15:49, 10 Feb 2005 (CET)

Apache not configured and no admin section

I find the binary installation useless. Apache is not configured at all and if I want to do this by hand, i'm unable to find any admin section / path or file.

Back to the source installation then.